Using it for a non-muffler application. Size listed is way off. Purchased 2" U-bolt. Actual inside dimension is 2-5/16". A pretty sloppy fit on a 2" OD pipe. The saddle is a different size than the u-bolt. Saddle ID was about 2-1/8" on some and 2-3/16" on two others. In addition, the saddle edges weren't aligned with each other. In most applications these incorrect sizes may not matter. In my case I will make it work but it certainly doesn't fit as expected. I bought the stainless steel for "looks". Sloppy is what I got.

It says 2" but that must be the inside diameter as the 2" is actually 2 1/4" or I had to reorder 1 3/4 for my 2" od pipe.

Easy to install for what I needed. A tad on the expensive side but I needed it. Came pretty quick. Good quality

Does the job well enough; good material and value. I didn't order enough so I had to go grab some from O'Reilly's and I found the O'Reilly's ones were -much- easier to torque down tight. Different thread pattern or u-bolt diameter maybe? Regardless, they did their job. Just required a little extra finesse to tighten up.

good

C'était parfiat pour ce quee j'aivais besion

Got this to clamp on spark arrestor on my sand rail exhaust pipe. Stainless steel material does the job and price is reasonable.

I have the "2 inch" size. Between the threads it's actually 2.20. And the threads are METRIC, M10 x 1.5, with 16 mm nuts, which just happen to fit a 5/8 wrench real nice. So don't lose the nuts!! I'm not using for a precision fit on an exhaust system, so these are just fine. Very robust.

I am using these outside and they are impressive just to look at. The quality appears to be very high.

I was expecting a 2” internal diameter. This is 2.25” and I cannot use it. Would exchange or refund.

Good value, decent for cheap SS clamp.

This clamp is a good choice in Stainless pipe or non stainless applications.

high quality - good price